Fujitsu LifeBook T901 - Adding a System to a User Group

Security functions
► If you do not want to initialise any further SmartCards, press
Esc
and remo ve the A dmin
SmartCard. NEVER write the PIN or PUK on the SmartCard under any circumstances!
Keep the SmartC ard and PIN/PUK in a safe place and protect
them from unauthorised access.
Adding a system to a user group
SystemLock 2
► Start the device.
► Call up BIOS Setup and select the SmartCard SystemLock page from the Security menu.

The following SmartCard SystemLock menu w ill be displayed:
Security
SmartCard SystemLock Item Specific Help
SmartCard SystemLock Not Installed
Install Single PC [Enter]
Install Group PC [Enter]
Installs the security
from a SystemLock Admin
SmartCard into this PC
without modifying any
data on the SmartCard.
A correct SmartCard is
required for a
permanent installation.
Enter PIN: [ ]
► Insert the Admin SmartCard for th e user group.

Enter PIN:
► Enter the PIN .

When the f
ollowing appears:
• ACCESS DENIED = You have confirmed the PIN incorrectly. You are then requested to
enter and confirm the new PIN again. After three failed a ttempts, the SmartC ard will
be blocked and can then only be activated again by entering the PUK.
Enter th
ePUK:
Fujitsu Technology Solutions 89