Fujitsu LifeBook T901 - Remote Access Enabling

Security functions
Remote Access Enabling –
F4
Requirement:
The device is c entra lly administered as part of an O rganisation Unit and is registered in a S ystemLock
Admin database. The SmartCard used for the group installation must ha ve been initialised beforehand
using the SystemLock Admin.EXE Windows program (see "
SmartCard user groups", Page 85).
In order to enable "re mote" access to a device for a user, or to grant one-time "remote"
access to a device for a guest or service technician, proceed as follows:
► Start the device.

The prompt to Insert a SmartCard will appear.
► Press the
F4
key.
The following dia
logue box will appear:
SmartCard SystemLock
Org Unit:
PC Group:
I-CODE 1:
I-CODE 2:
Company Department 1
Group 1
0123456789ABCDEF
0123456789ABCDEF

The user m ust then
contact the administrator or the admin istration hotline and
inform them of th
e data and codes displayed .
The adm inistrator then specifies the type of the once-only access rights:
User
access
The user can boot the system once.
Service
access
The user has one-time access to the BIOS for service purposes, without
access to the SystemLock functions.
Admin
access
The user h as access to the BIO S and the SystemLock functions, e.g. for
activating the device when the associated SmartCard has been lost.
An activation code w ill be generated that depends on the access rights granted;
this will be given to the user by the Hotline.
The user must now press the Enter key on the PC to be activated, enter the first half (Code
1) of the activation code and confirm the entry by pressing Enter. Th e dialogue box for
entering t he second half (Code 2) of the activation code will appear. If an incorrect entry
is made, there is no limit to the number of times the process can be repeated.
When all 32 characters of the activation code have been co rrectly entered, the
device will boot with the rights assigned by the administrator, in the same way
as if a corresponding SmartC ard were inserted.
The activation code can only be used once to start the device; it immediately becomes
invalid when the device bo o ts. If you wish to switch off the device and start it again
without your SmartCard, the procedure described above must be repeated each time.
Fujitsu Technology Solutions 93