Security functions
Error messages
Errormessages
In this chapter you will find the error messages which are genera ted by the
mainboard and the S martCard reader.
Error Cause
Boot access denied
The SmartCard has no access rights to the system.
Check your
SmartCard
The S martC ard is either inserted incorrectly or it is not a suitable SystemLock
SmartCard.
SmartCard reader
FA I L U R E
An error has occurred on the serial port to the SmartCard reader. If this error
occurs frequently, the connection between the SmartCard reader and the
mainboard must be checke d, or the SmartCard reader must be replaced.
While the error is present, access to the system is blocked.
Non-authorised
SmartCard
The SmartCard can not be used on this device. The SmartCard has been
configured for a different device.
SystemLock
installation
FA I L E D :
An error occurred while installing SystemLock. Do not switch off the device,
insert the " BIOS Flash diskette" instead.
Perform a BIOS update and try th e installation process again.
The SmartCard is
blocked.
Enter the PUK:
Yo u have exceeded the maximum allowed num ber of incorrect PIN entries.
The Sm artCard is blocked. Enter the administrator PUK to re-activate the
SmartCard. You must then enter a new User PIN to restart the system.
Using the secu
rity function of the tablet keys
If you have allotted a supervisor and/o r use r password in the form of tablet key combinations as
described below, you can use the tablet keys to enter this when you start your device .
Setting the Supe rv isor password
► Select Start - Run.
► Enter the following at the command line: C:\Program Files\Fujitsu\Security
Panel Application\Supervisor\FJSECS.EXE.
► Confirm with
Enter
.
► Follo w the instructions on the screen.
Settin
g the User password
► Select Start - All Programs.
► Selec
t S ecurity Pa nel Application – Secu rity Panel Application.
► Follo w the instructions on the screen.
Fujitsu Technology Solutions 95
To Next Page
Loading...
