Fujitsu M2488 - Installation Instructions; Introduction; Preparing the M2488 and Its Optional Equipment

M2488 USER’S GUIDE INSTALLATION INSTRUCTIONS
April 1997 CG00000-011403 REV. A 2-1
CHAPTER 2
INSTALLATION INSTRUCTIONS
2-1 INTRODUCTION
This chapter contains information on installing the M2488 tape drive and optional equipment. This
chapter is divided into the following major paragraphs:
2-2 PREPARING THE M2488 AND ITS OPTIONAL EQUIPMENT
2-3 CONFIGURATIONS
2-4 UNPACKING INSTRUCTIONS
2-5 EQUIPMENT INSPECTION
2-6 ASSEMBLY INSTRUCTIONS
2-7 PREPARATION FOR USE
2-2 PREPARING THE M2488 AND ITS OPTIONAL EQUIPMENT
Upon receipt of your equipment, follow the procedures in the order listed below:
STEP PROCEDURE WHERE?
1 Unpack the M2488 and attached medium changer (if
applicable).
User’s Guide, Chapter 2, paragraph 2-4
2 Inspect the M2488 and medium changer (if applicable). User’s Guide, Chapter 2, paragraph 2-5
3 Assemble the M2488. User’s Guide, Chapter 2, paragraph 2-6
4 Configure the M2488. User’s Guide, Chapter 4
5 Operating the M2488. User’s Guide, Chapter 5
NOTICE
SERVICE
PERSONNEL
ONLY