Fujitsu M2488 - Preface

M2488 USER’S GUIDE PREFACE
C144-E018-03EN i
PREFACE
The M2488 User’s Guide provides the information necessary for the user to operate the M2488 Car-
tridge Tape Drive.
Chapter 1 Introduction
This chapter provides an overview of the M2488 Cartridge Tape Drive and its optional equipment.
Chapter 2 Installation Instructions
This chapter provides procedures for the preparation and assembly of the M2488 Cartridge Tape
Drive.
Chapter 3 Controls and Indicators
This chapter describes the controls, indicators and connectors for the M2488 Cartridge Tape Drive
and its optional equipment.
Chapter 4 Configuration
This chapter describes the configuration menus of the M2488 Cartridge Tape Drive.
Chapter 5 Operating Instructions
This chapter provides procedures for operating the M2488 Cartridge Tape Drive and its optional
equipment.
Chapter 6 Maintenance and Servicing
This chapter describes the user maintenance and servicing of the M2488 Cartridge Tape Drive.
Chapter 7 Parts List
This chapter describes the M2488 models and optional equipment available.
The ANSI X3.131-199x SCSI specification may be purchased from:
American National Standard Institute, Inc.
1430 Broadway, New York, N.Y. 10018
Tel. (212) 642-4900
SCSI-2 unreleased documentation X3B5/87-099 may be obtained from:
Global Engineering Documents
2805 McGaw
Irvine, CA 92714
CONVENTION
Hexadecimal numbers are denoted by an “h” following the number (e.g. 23h) or 0xNN.
Binary numbers are denoted by a “b” following the number (e.g. 001b).