Fujitsu M2488 - Equipment Inspection; 2-5.1 Inspect the M2488 Tape Drive; 2-5.2 Inspect the ACL; 2-5.3 Inspect the FACL

INSTALLATION INSTRUCTIONS M2488 USER’S GUIDE
2-4 CG00000-011403 REV. A April 1997
2-5 EQUIPMENT INSPECTION
After unpacking, inspect the equipment. If any damage is found, note the type of damage and location.
Also note any damage to the packing container. Contact your distributor for further instructions for
handling the damaged equipment.
2-5.1 Inspect the M2488 Tape Drive
Inspect the tape drive for the following items. Upon completion, inspect the medium changer, if
attached, or continue with the assembly instructions.
• Visually examine the chassis for dents and cracks.
2-5.2 Inspect the ACL
Inspect the ACL for the following items. Upon completion, continue with the assembly instructions.
• Visually examine the chassis for dents and cracks.
2-5.3 Inspect the FACL
Inspect the FACL for the following items. Upon completion, continue with the assembly instruc-
tions.
• Visually examine the chassis for dents and cracks.
• Check the door lock by pressing on the lock lever and opening the door.
• Check the carrier movement by rotating the carrier knob. Refer to the Controls and Indicators in
Chapter 3 of the User’s Guide for the location of the knob.