Fujitsu M2488 - Configuration; Chapter Introduction; Setting Menu; Table 4-1. Operator Panel Top Level Menus - Settings

M2488 USER’S GUIDE CONFIGURATION
April 1997 CG00000-011403 REV. A 4-1
CHAPTER 4
CONFIGURATION
4-1 CHAPTER INTRODUCTION
This chapter provides information on the following subject areas:
4-2 SETTING MENU
4-3 LOADING NEW FIRMWARE
4-4 DRIVE INFORMATION
4-5 MODE PAGE SETTINGS
4-2 SETTING MENU
This procedure describes the steps required to access and configure the user settable options. All dis-
plays refer to the Operator Panel display on the M2488 tape drive or the medium changer. The menu
structure is shown below with the SETTING menu shaded:
Table 4-1. Operator Panel Top Level Menus - Settings
TEST
and
UNLOAD
pressed
TEST
and
UNLOAD
released
*
→
OFFLINE
→
DIAGMODE
Selection and execution of off-
line diagnostics
Product Guide
Section 8-4
↓
START
SETTING
TEST
→
Access and configure user
settable options
User’s Guide
Section 4-2
LOADCODE
Copy new firmware from a code
image tape cartridge into non-
volatile memory of M2488.
User’s Guide
Section 4-3
INQUIRY
View M2488 Information User’s Guide
Section 4-4
MODE PGS
Display or change selected Tape
Unit or Medium-Changer Mode
Pages
User’s Guide
Section 4-5
FACTORY
Change factory mode settings,
enable factory mode, or enable
factory diagnostics.
Product Guide
Section 8-5