M2488 USER’S GUIDE OPERATING PROCEDURES
April 1997 CG00000-011403 REV. A 5-7
5-7.5 Check Messages
This type of message is displayed when a drive error is detected and requires operator intervention.
The messages either contain CHK with a hexadecimal error code or indicates that the operator has
made an error. Refer to Section 6-4 ERROR RECOVERY.
5-7.6 Ozone Messages
This type of message is displayed where a drive error is detected. The scrolling message contains
OZONE NNNNNNN and text describing the error. Refer to Section 6-4 ERROR RECOVERY.
5-8 MEDIUM CHANGER MESSAGES
5-8.1 Position Indicator
The following messages are displayed on the Position Indicator of the Medium Changer operator
panel.
INDICATION DESCRIPTION
(unlit) Magazine is not mounted.
number Value indicates the magazine position.
- Magazine is mounted, START has not been pressed.
A Autoloader is operating:
1. power turned on with a magazine mounted.
2. magazine stopped for loading or ejecting.
C Cleaning tape is running.
E Indicates autoloader is in error status. This may indicate the
magazine position in case of a feed or return error.
F Magazine has been ejected and is ready to replace.
H Cartridge was inserted manually without using a magazine.
To Next Page
Loading...
