M2488 USER’S GUIDE OPERATING PROCEDURES
April 1997 CG00000-011403 REV. A 5-9
5-9.3 Eject the ACL Magazine
5-9.4 ACL Auto Mode Operation
5-9.5 ACL System Mode Operation
5-9.6 ACL Hand Mode Operation
a. The tape cartridge may be unloaded manually by pressing
RESET
, then
UNLOAD
.
STEP
ACTION
1
Press
RESET
. The MAGAZINE START LED turns off and
NT RDYU
OR
NT RDYF
is dis-
played.
2 If a cartridge is loaded, press
UNLOAD
. The cartridge is returned to the magazine.
3
Press
EJECT
.
EJECTING
is displayed while the magazine moves up.
4
When the position indicator changes to
F
, remove the magazine by the handle.
STEP
ACTION
1 The first cartridge is loaded and the tape is positioned at BOT. The drive enters the ready state.
2
When the LOAD UNLOAD command is issued
a
, the tape cartridge is ejected and stored in the mag-
azine. The next cartridge is automatically loaded.
STEP
ACTION
1
✳N
is displayed.
2 ACL operation is controlled by the SCSI medium changer commands.
3 When the next LOAD UNLOAD command is issued, the tape cartridge is ejected and stored in the
magazine.
4 When MOVE MEDIUM command is issued, the desired cartridge is loaded.
STEP
ACTION
1 Insert the cartridge directly into the cartridge entry slot on the tape drive.
2
When the cartridge is inserted, the position indicator displays an
H
.
3 Push in the cartridge until it stops.
4 Continue with the Step 2 of the procedure for loading a tape cartridge without the ACL in paragraph
5-4.1.
5 The tape cartridge is unloaded using one of the methods described in paragraph 5-4.3.
To Next Page
Loading...
