M2488 USER’S GUIDE INSTALLATION INSTRUCTIONS
April 1997 CG00000-011403 REV. A 2-5
2-6 ASSEMBLY INSTRUCTIONS
These paragraphs describe the assembly and installation of the M2488 tape drive and of the optional
equipment. Use the following flowchart, in the order presented, as a guide to installing the M2488.
Each flowchart block indicates the procedure to be performed and the paragraph in this manual where
the procedure is located.
2-6.1 General Installation and Assembly Instructions
Prior to assembly, ensure all SCSI cables and power cords have been disconnected. The M2488
should be placed as near as possible to the power source.
2-6.1.1 Air Flow and Service Clearances
Allow a gap of 50 mm at the rear of the drive for heat dissipation.
Allow a 620 mm servicing area to the rear, with drive extended, for rack-mounted drives.
Installation Procedures
Install IPM
2-6.2
General Instructions 2-6.1
Connect cables and
power cord 2-6.3
Configure the drive 2-7
To Next Page
Loading...
