Fujitsu M2488 - 5-5.2 Unload Tape Cartridges from an ACL Magazine; 5-5.3 Load Tape Cartridges into a FACL Magazine; Figure 5-3. FACL Magazine

OPERATING PROCEDURES M2488 USER’S GUIDE
5-4 CG00000-011403 REV. A April 1997
5-5.2 Unload Tape Cartridges from an ACL Magazine
The procedure is the same for both the 5 and 10-cartridge magazine
.
Figure 5-3. FACL Magazine
5-5.3 Load Tape Cartridges into a FACL Magazine
STEP ACTION
1 Remove magazine from the ACL.
2 Release cartridge lock. If only one cartridge is to be unloaded, press the cartridge lock bar. If several
cartridges are to be unloaded, press the unlock button.
3 Remove the cartridge from the magazine.
STEP ACTION
1 Insert tape cartridges, from either side A or B as shown in Figure 5-3, into the tape cartridge slot. *
2 Press on the cartridge to ensure the magazine lock has engaged.
3 If file protect for all cartridges within the magazine is desired, slide the file protect switch to the file
protect position. This protects all cartridges without regard to individual cartridge file protect set-
tings.
* Cartridges may be loaded into the magazine while mounted in the FACL, except for the bottom slot.
File Protect Switch
Unlock button
Cartridge
Lock bar