Fujitsu M2488 - 3-3.2 ACL Rear Panel Cables; Figure 3-5. ACL Rear Panel Cables

CONTROLS AND INDICATORS M2488 USER’S GUIDE
3-6 CG00000-011403 REV. A April 1997
3-3.2 ACL Rear Panel Cables
Figure 3-5 and Table 3-5 illustrate and describe the rear panel of the ACL.
Figure 3-5. ACL Rear Panel Cables
8 Message Display Displays the background, host, fixed, not-ready, check or
configuration messages with eight alphanumeric characters,
including symbols.
9
RESET
push-button Press to select the tape drive not-ready state and the ACL
stop state. Press to reset an error display.
10
UNLOAD
push-button Press to manually unload and eject cartridge into magazine.
Only operates when the tape drive is not ready.
11
START
push-button Press to move the magazine to the selected position and
load the tape cartridge.The tape cartridge is set at BOT and
the drive enters the ready state.
12
TEST
push-button Pressed with the
UNLOAD
push-button to enter the offline
(menu) mode. Press to display additional messages.
13
SHIFT
push-button Press with the
START
push-button in the test mode.
14 COMP LED Illuminates when data compression is selected.
15
MODE SEL.
push-button Press to change the ACL mode to system or auto.
16 AUTO LED Illuminates to indicate the ACL is in the AUTO mode.
17
EJECT
push-button Press to eject the cartridge into the magazine and eject the
magazine.
15/10
MODE SEL
plus
UNLOAD
push-
buttons
Moves the magazine up.
17/10
EJECT
plus
UNLOAD
push-but-
tons
Moves the magazine down.
Table 3-4. ACL Front Panel Controls and Indicators (Continued)
FIGURE AND
INDEX NO.
CONTROLS AND
INDICATORS
DESCRIPTION
1
2