Fujitsu M2488 - Table 4-2. Settable Options Description

CONFIGURATION M2488 USER’S GUIDE
4-2 CG00000-011403 REV. A April 1997
a. If there is an outstanding SCSI command or if there is a tape loaded in the tape drive then Off-line
mode cannot be entered.
Navigation keys:
To navigate through the options, settings, and to make changes from the Operator Panel:
Press START to move forward through the options or settings. It will also increment the settings num-
bers.
Press SHIFT and START to move backward through the options or settings. It will also decrement the
settings numbers.
Press RESET to move from settings to option or to leave setting mode.
Press TEST to move from the option to settings.
Press UNLOAD to select a number field for multiple digit numbers.
Setting Procedure:
Remove all cartridges and magazine prior to performing this procedure.
Step 1. Press and hold both the TEST and UNLOAD keys, wait for OFFLINE to be displayed then
release both keys.
a
Once the keys are released then the first item, DIAGMODE, in the
main Off-line menu will be displayed. (Keys must be held for approximately 2 seconds
before Off-line mode is entered.)
Step 2. Press the START pushbutton until SETTING is displayed. The settable options are
described in Table 4-2.
Step 3. Press the TEST pushbutton.
Step 4. The first option, 70: S.TAR, is displayed. Press TEST to view the setting or START to
view next option.
Step 5. The settings may be saved at option 89: WTROM.
Step 6. When options are set and saved, press RESET twice to return to ✳ or ✳N.
Table 4-2. Settable Options Description
OPTION SETTINGS DESCRIPTION
DEFAULT
SETTINGS
70: S.TAR TARGID: 0 The SCSI target ID assigned to the M2488 system. 0
71: S.LUN LUN: 0 The logical unit number assigned to the tape drive. 0
72: S.LNG ENGLISH
FRENCH
GERMAN
SPANISH
ITALIAN
Select the language of the fixed display messages. ENGLISH
73: S.RDY BOTRDY:N
Y
If N, the BOT RDY message is not displayed on the operator panel
when the cartridge is loaded and positioned at the physical load
point.
If Y, the BOT RDY message is displayed on the operator panel when
the cartridge is loaded and positioned at the physical load point.
N