M2488 USER’S GUIDE CONFIGURATION
April 1997 CG00000-011403 REV. A 4-3
74: S.
✳
N
✳
N: NO
YES
If NO, the drive’s Target ID is not displayed when no cartridge is
loaded.
If YES, the drive’s Target ID is displayed when no cartridge is dis-
played.
NO
75: S.ITS INTEN: 0 Adjusts intensity of the Operator Panel display. 0 is brightest, 3 is
darkest.
0
76: S.ACL ACL:AUTO
SYS
Select the automatic or system mode for the medium changer at
power up. If a medium changer is not installed, this setting has no
effect on unit operation.
AUTO
77: S.FT1 S.FT1: 00 Sets an additional function. The bits are described in Table 4-3. 00
78: S.FT2 S.FT2: 00 Sets an additional function. The bits are described in Table 4-4. 00
79: S.FT3 S.FT3: 00 Sets an additional function. The bits are described in Table 4-5. 00
80: S.FT4 S.FT4: 00 Sets additional functions. The bits are described in Table 4-6. 00
81: FSGRP NONE
FSGRP S
FSGRP T
FSGRP U
FSGRP V
FSGRP W
FSGRP X
FSGRP Y
FSGRP Z
Selects a feature setting group. Each group enables a subset of the
features controlled by the FT1 through FT5 settings.
A feature can be enabled either by a feature group or by setting the
appropriate values in the FT1 through FT5 settings.
A feature is disabled only if both the feature group and the FT1
through FT5 settings are not enabled.
The actual features for each group are not specified in this manual.
NONE
82: S.SDT SDTR: N
Y
If N, the target will not initiate a Synchronous Data Transfer Request
If Y, the target will initiate a Synchronous Data Transfer Request if
the initiator does not.
N
83: S.WDT WDTR: N
Y
If N, the target will not initiate a Wide Data Transfer Request
If Y, the target will initiate a Wide Data Transfer Request if the initia-
tor does not.
N
84: S.FT5 S.FT5: 00 Sets additional functions. The bits are described in Table 4-7. 00
85: LIBRY NONE
KOALA
ATL
Selects a Library Interface setting. This option is used by Manufac-
turing to configure and enable a Library RS-232 Interface port on the
tape drive for attachment to a particular tape Library.
NONE
86: S.MCL MCL: 4 Medium changer logical address. 4
89: WTROM WTROM: Y
N
If Y, the setting data is written to the nonvolatile memory.
If N, the setting data is not written to the nonvolatile memory.
Y
Table 4-2. Settable Options Description (Continued)
OPTION SETTINGS DESCRIPTION
DEFAULT
SETTINGS
To Next Page
Loading...
