Fujitsu M2488 - Facl Operating Instructions; 5-10.1 Open and Close FACL Door; 5-10.2 Select the FACL Mode; 5-10.3 Mount the FACL Magazine

OPERATING PROCEDURES M2488 USER’S GUIDE
5-10 CG00000-011403 REV. A April 1997
5-10 FACL OPERATING INSTRUCTIONS
The FACL is shown in Figure 5-6. Its operation is presented in the following paragraphs.
Figure 5-6. FACL
5-10.1 Open and Close FACL Door
To open the spring-loaded door, press PUSH. If the door does not open, press down on the lock tab
(side panel) and open the door.
To close the door, press PUSH.
5-10.2 Select the FACL Mode
After selecting the mode with this procedure, only use the procedures for that mode.
5-10.3 Mount the FACL Magazine
Refer to Figure 5-7.
STEP ACTION
1 Press
MODE SEL.
until the AUTO LED illuminates for the auto mode, the SYSTEM LED illumi-
nates for the system mode or the MANUAL LED illuminates for the manual mode.
STEP ACTION
1 Open the door (see paragraph 5-10.1) and press PUSH on the magazine loading section. The mount-
ing tray moves forward.
2 Hold the magazine handle and insert the magazine into the mounting tray.
3 Press PUSH on the mounting tray until the device locks into the FACL.
4 Close the door (see paragraph 5-10.1).
lock tab