Fujitsu M2488 - 4-2.1 Setting Target ID; 4-2.2 Emergency ROM Load

CONFIGURATION M2488 USER’S GUIDE
4-8 CG00000-011403 REV. A April 1997
4-2.1 Setting Target ID
** NOTE **
Remove medium changer magazine (if mounted) prior to performing
this procedure.
The following procedure describes the steps required to set the Target ID.
4-2.2 Emergency ROM Load
a. If there is an outstanding SCSI command or if there is a tape loaded in the tape drive then Off-line
mode cannot be entered.
Step 1. Press and hold both the TEST and UNLOAD keys, wait for
OFFLINE
to be displayed
then release both keys.
a
Once the keys are released then the first item,
DIAGMODE
,
in the main Off-line menu will be displayed. (Keys must be held for approximately 2
seconds before Off-line mode is entered.)
Step 2. Press the START pushbutton until
SETTING
is displayed.
Step 3. Press the TEST pushbutton.
Step 4. The first option,
70: S.TAR
, is displayed. Press TEST to view the setting. The set-
ting may be incremented by pressing START or decremented by pressing SHIFT and
START.
Step 5. Press TEST to return to
70: S.TAR
Step 6. Press SHIFT and START until
89: WTROM
is displayed.
Step 7. Press TEST to view settings at option
89: WTROM
.
Step 8. Press START until
y
is displayed.
Step 9. Press the TEST pushbutton to write the setting to ROM.
Step 10. Press TEST to return to
89: WTROM
.
Step 11. Press RESET twice to return to ✳.
Step 1. From a powered-off state, turn power to on while pressing SHIFT + RESET. Release
SHIFT + RESET when
SELFTEST
is displayed.