Fujitsu M2488 - Page 98

INDEX M2488 USER’S GUIDE
I-2 CG00000-011403 REV. A April 1997
ENVIRONMENTAL INFORMATION UG 1-8
Non-Operating UG 1-8
Operating UG 1-8
ERROR RECOVERY UG 6-3
CHK XX UG 6-3
NVRAM Initialization UG 6-3
OZONE UG 6-3
F
FACL OPERATING INSTRUCTIONS UG 5-10
Eject the FACL Magazine UG 5-11
FACL Auto Mode UG 5-12
FACL Cleaning UG 5-12
FACL Manual Mode UG 5-12
FACL System Mode UG 5-12
Mount the FACL Magazine UG 5-10
Open and Close FACL Door UG 5-10
Select the FACL Mode UG 5-10
FT1 Bit UG 4-4
FT2 Bit UG 4-5
FT3 Bit UG 4-5
FT4 Bit UG 4-5
FT5 Bit UG 4-7
I
INSPECTION UG 2-4
INSTALLATION INSTRUCTIONS UG 2-1
IPM UG 2-6
L
LOADING NEW FIRMWARE UG 4-9
Binary Code Image File UG 4-10
Code Image Tape Cartridge UG 4-9
M
MAGAZINE PROCEDURES UG 5-3
FACL Cleaning Cartridge UG 5-5
Load Tape Cartridges UG 5-3
Load Tape Cartridges (ACL) UG 5-3
Load Tape Cartridges (FACL) UG 5-4
Unload Tape Cartridges (ACL) UG 5-4
Unload Tape Cartridges (FACL) UG 5-5
Maintenance
PREVENTIVE UG 6-1
MAINTENANCE AND SERVICING UG 6-1
MEDIUM CHANGER MESSAGES UG 5-7
Messages
MEDIUM CHANGER UG 5-7
OPERATOR PANEL UG 5-6
MODE PAGE SETTINGS UG 4-13
O
Operating Instructions