TX100 S2 Service Supplement 13
2Procedure
V CAUTION!
The actions described in these instructions should only be performed by
service personnel.
Ê First of all please familiarize yourself with the safety instructions in the
chapter "Safety instructions" on page 15.
Ê Ensure that all required manuals (see Service DVD) are available, print out
the PDF files if necessary. You will definitely need the Operating Manual for
the server, the Options Guide for the server and the Technical Manual for the
system board.
Ê Shut down the server correctly, switch it off, pull all power cords out of the
power outlet, and open the server as described in the chapter "Replacement
routines" on page 23.
Ê Replace the defective component as described in the relevant chapter.
Ê Follow the below procedures described in the Operating Manual:
Ê Close the server.
Ê Connect the cables.
Ê Connect the server to the power outlet.
Ê Start the operating system.
Ê If necessary, configure the server as required.
To Next Page
Loading...
