TX100 S2 Service Supplement 109
Replacement routines
4.10 Replacing the USB Flash Module (UFM)
Ê Shut down the server and disconnect the AC power cord from the system.
Ê Remove the side cover as described in section 4.1.1.1 on page 23.
Ê Open the HDD cage as described in section 4.1.2.1 on page 25.
Figure 93: Removing the UFM board (A)
Ê Remove the nylon screw on the defective UFM board (1).
Ê Disconnect and remove the defective UFM board (2).
To Next Page
Loading...
