TX100 S3 Core Edition Operating Manual 23
3 Installation steps, overview
This chapter contains an overview of the steps necessary to install your server.
Links take you to sections where you can find more detailed information about
the respective steps:
Ê First of all, it is essential that you familiarize yourself with the safety
information in chapter "Important information" on page 25.
Ê Transport the server to the place where you want to set it up.
Ê Unpack all parts, check the contents of the package for visible transport
damage and check whether the items delivered match the details on the
delivery note (see section "Unpacking the server" on page 38).
Ê Make sure that all necessary manuals (see "Documentation overview" on
page 12) are available; print out the PDF files if required.
Ê Components that have been ordered additionally may be delivered loose
with the server. Install these in the server as described in the supplied
documentation.
Ê Set up the server (see section "Setting up the server" on page 39).
Ê Wire the server. Follow the instructions in sections "Connecting devices to
the server" on page 40 and "Notes on connecting / disconnecting cables" on
page 42.
Ê Connect the server to the mains (see section "Connecting the server to the
mains" on page 41).
Ê Familiarize yourself with the controls and indicators on the front and rear of
the server (see section "Control elements and indicators" on page 44).
Ê Configure your server as described in section "Initial operation" on page 48.
To Next Page
Loading...
Need help?
General