88 Operating Manual TX100 S3 Core Edition
Troubleshooting and tips
Ê After the rebuild and installation process is complete, shut down your server
and reconnect the additional hard disk drives to SATA connectors "SATA 2"
and "SATA 3" as described above.
Ê Complete the initial configuration of your Headless server as described in
section "Initial operation" on page 48.
Ê Use the ServerView RAID Manager to recreate the RAID array including the
two additional hard disk drives (IDs 2 and 3) according to the RAID
configuration values you have noted down before resetting the Headless
server.
V CAUTION!
Before clicking the Create button, ensure that Init mode is set to No
initialization! Otherwise the user data on the additional hard disk
drives will be lost!
8.11 Power-on indicator reports an error
It is no longer possible to establish a Remote Desktop connection or
access any service or file on the Headless server. Additionally the Power-
on indicator reports an error by flashing continuously.
There are two different error states indicated by the the Power-on indicator:
The Power-on indicator flashes at a high frequency (2 Hz, twice every
second).
This error state indicates that an error occurred during the early BIOS POST
phase. The system is unable to finish the BIOS POST phase successfully due
to an error involving the system board. Additionally a beep code might be
audible. A typical error cause might be an improperly seated memory module.
In order to resolve such problems, proceed as follows:
Ê Terminate all applications and shut down the server.
I If the server does not shut down properly, press and hold the On/Off
button for five seconds, until the server switches off.
Ê Disconnect the AC power cord from the system.
Ê Pull the locking lever and fold out the side cover.
Ê Unlatch and remove the side cover.
To Next Page
Loading...
Need help?
General