Fujitsu PRIMERGY TX100 S3 Core Edition User Manual

TX100 S3 Core Edition Operating Manual 75
Starting up and operation
6.6 Configuring the onboard SATA controller
In order to configure the onboard SATA controller please proceed as follows:
After booting the operating system from HDD
Ê Establish a Remote Desktop connection as described in section 6.3.3 on
page 49.
Ê Use ServerView RAID Manager to configure and manage your SATA
controller and attached devices.
For further information, please refer to the “ServerView Suite RAID
Management“ user guide available on your ServerView Suite DVD 2 or from
the Fujitsu Technology Solutions manuals server at
http://manuals.ts.fujitsu.com. Point to Industry Standard Servers - Software -
ServerView Suite - Administration and Manageability - RAID Management.
For the Japanese market please use the following URL:
http://primeserver.fujitsu.com/primergy/manual/
After booting the server from the Maintenance & Recovery DVD
Ê Click Start Shell to open the command line interface.
Ê Enter the ServerView RAID command amcli.exe.
amCLI is a command line interface to ServerView RAID Manager. It can be
used to create, delete or manage RAID arrays.
For further information on amCLI, please refer to the “ServerView Suite
RAID Management“ user guide available on your ServerView Suite DVD 2
or from the Fujitsu Technology Solutions manuals server at
http://manuals.ts.fujitsu.com. Point to Industry Standard Servers - Software -
ServerView Suite - Administration and Manageability - RAID Management.
For the Japanese market please use the following URL:
http://primeserver.fujitsu.com/primergy/manual/

Fujitsu PRIMERGY TX100 S3 Core Edition Specifications

General

Brand	Fujitsu
Model	PRIMERGY TX100 S3 Core Edition
Category	Server
Language	English