Fujitsu PRIMERGY TX100 S3 Core Edition - Remote Desktop Connection Methods; Connect by Computer Name; Connect by IP Address

50 Operating Manual TX100 S3 Core Edition
Starting up and operation
In this case, connect the client to your server by its default name:
– Connect by IP address
If DHCP is not available on your network or if your server is directly
connected to the client computer the following default network settings
are applied:
Ê Configure your client’s static IP address on subnet 192.168.10.x with
subnet mask 255.255.255.0.
Example: 192.168.10.20
Subnet mask: 255.255.255.0
For further details on how to configure network settings, refer to
section "Network configuration (optional)" on page 53.
V – It is highly recommended to take note of the original
network setting values (e.g. IP address, subnet mask,
default gateway) before altering the network configuration.
– Ensure that the IP address is not your server’s default
address (192.168.10.10) and is not otherwise in use on the
network.
I The subnet mask is used by the TCP/IP protocol to determine
whether a host is on the local subnet or on a remote network.
Default computer name: HEADLESS
Default IP address: 192.168.10.10
Default subnet mask: 255.255.255.0
Default gateway: 192.168.10.1