TX150 S6 Operating Manual 77
Starting up and operation Switching the server on and off
Switching the server off
The power-on indicator lights up green (item 2 in figure 24 on page 67).
Ê Shut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
power-on indicator lights up orange.
I If the operating system does not switch the server off automatically, press
the On/Off button for at least four seconds and/or send a corresponding
control signal.
Other On/Off options
In addition to the On/Off button, the server can be switched on and off in the
following ways:
– Specified switch on time / switch off time
The ServerView program allows you to set a time at which the server is to
be automatically switched on or off.
– Ring indicator
The server is switched on by an internal or external modem.
– Wake up On LAN (WOL)
The server is switched on by a command from the LAN.
– After power failure
The server is automatically switched on following a power failure (depending
on the BIOS settings).
– “Power override” function
The server can be switched off immediately by pressing and holding the
On/Off button (approx. 4-5 sec.).
V CAUTION!
There is a risk that data may be lost.
– IPMI
The server is switched on from an IPMI console (via the COM1 serial
interface or the RJ45 LAN interface).
To Next Page
Loading...
