EasyManuals Logo

Fujitsu SCALEOVIEW S17-2 User Manual

Fujitsu SCALEOVIEW S17-2
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Maintaining Units Periodic Inspections
Page 40 MDE-3893P Encore® and Eclipse® Series Owner’s Manual · December 2011
After first filter
change—Every
300,000 gallons
(1.1 million
liters), every six
months, or when
fuel delivery rate
significantly
slows.
CAUTION
Do not attempt to perform any of these tasks yourself.
Performing these tasks incorrectly could result in severe injury
or death.
WARNING
Note: Most complaints regarding continual slow flow rate from the dispenser are
caused by clogged filters
Every three
months
Clean CRIND
device printer
Clean the CRIND device M00317A00X printer
using the printer cleaning card Q13400. Follow
instructions in
“Cleaning the CRIND Device in
the M00317A00X Printer” on page 59 (use
Moore Wallace M05194B001).
Clean the CRIND device M04119A001 (USB)
printer using the M05194B001 cleaning kit.
Follow instructions included in the kit.
Owner
Every three
months
Clean CRIND
device display
Clean the CRIND device display regularly with a
mild detergent and soft cloth using Moore Wallace
M05194B001 cleaning kit. Be careful not to scratch
the display. Do not use an abrasive cleaner, or glass
cleaner or detergent that contains ammonia.
Ammonia will damage plastic display windows and
door materials.
Owner
Every six months Inspect and
lubricate
Shear Valves
To check valve operation, perform the following
tasks:
1. Trip the valve.
2. Authorize the hose at the console, if required.
3. Lift the operating handle.
4. Place the discharge nozzle in an approved
container.
5. Squeeze the nozzle operating lever. If flow
continues after several seconds, the valve is
defective and must be serviced or replaced.
6. Place a few drops of SAE10 oil on Shear Valve
body shaft.
7. Open and close valve with a wrench several
times.
8. Place valve back in service.
Note: If repair is required, call an ASC/CSC.
• Owner—Inspect and
lubricate
• ASC/CSC only—Repair
If you are not sure which device is the Shear Valve or have not
been trained regarding its use or service, have the ASC/CSC
inspect and lubricate this device for you.
CAUTION
CAUTION
Do not attempt to make these repairs yourself. Doing so could
result in severe injury or death.
WARNING
Recommended
Frequency Components Recommended Maintenance
Who Performs the
Inspection/Repair

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu SCALEOVIEW S17-2 and is the answer not in the manual?

Fujitsu SCALEOVIEW S17-2 Specifications

General IconGeneral
BrandFujitsu
ModelSCALEOVIEW S17-2
CategoryMonitor
LanguageEnglish

Related product manuals