MDE-3893P Encore® and Eclipse® Series Owner’s Manual · December 2011 Page 41
Periodic Inspections Maintaining Units
Every six months Pump pulleys,
belts, and belt
tension
1. Remove power to the unit. • Owner—Inspect
• ASC/CSC only—Repair
and test
CAUTION
To prevent an injury, remove power to the pump/dispenser
before you start the maintenance activity.
WARNING
To avoid injury, avoid getting your fingers in a pinch point
between the pulley and belt during an inspection.
CAUTION
2. Inspect belts for fraying/cracks.
3. Inspect pulleys for excessive wear in grooves and
excessive bearing play.
4. Ensure that there is no more than one inch of play
on either side of the belt, by pressing the belt
midway between the two pulleys.
Note: If repair is required, call an ASC/CSC.
CAUTION
Do not attempt to make these repairs yourself. Doing so could
result in severe injury or death.
WARNING
Every six months Nozzle hooks
and shafts
1. Lubricate with silicone grease, if required.
2. Check for damage.
3. Ensure that the locking tab locator is not broken.
The locking tab locator helps hold the nozzle in
the nozzle boot and enables the station owner to
lock the nozzle boot with a clasp padlock.
Note: If repair is required, call an ASC/CSC.
• Owner—Inspect
• ASC/CSC only—Repair
and test
CAUTION
Do not attempt to make these repairs yourself. Doing so could
result in severe injury or death.
WARNING
Every six months Door locks Lubricate with a graphite lubricant or lock oil. Follow
manufacturer’s instructions. Do not over-lubricate.
Owner
Every 12 months
or as required in
harsh climate
Polish unit
Polish metal parts with Nu Finish
®
car polish. Do not
use automobile wax. Refer to
“Performing General
and Component Maintenance Inspections” on
page 32.
Owner
Recommended
Frequency Components Recommended Maintenance
Who Performs the
Inspection/Repair
To Next Page
Loading...
Need help?
General