Working with the Tab let PC
Replacing the stylus tip
With use, the stylus tip may become worn or may pick up foreign particles that can s cratch the screen.
A damaged o r worn tip may not move freely, causing unpredictable re sults when using the stylus.
If your st ylus exhibits these proble ms, replace the stylus tip. To do this, use the su pplied tool (1).
1
► To remove the tip, position it in the gap
between the two ends of the tool supplied.
► Pinch the tw o ends of the supplied tool
together so that the tip is firmly clasped,
then pull it from the barrel.
► Rep lace the tip with one of the ne w tips
that were supplied with y our stylus. Insert
the flat end of the tip into the barrel
and exerting gentle pressure, push it
in until it is firmly in place.
If the tip is worn or damaged, discard it.
Installing a stylus tether
Attach the stylus with a stylus tether to prevent accidentally d ropping it or losing it.
► Fasten the stylus tether to the attachment points on the stylus and the Tablet PC.
Fujitsu 33
To Next Page
Loading...
