Troubleshooting and tips
The wireless connection to a net
work does n ot work
Thewireless connection toanet workdoes notwork
Cause Tro ubleshooting
The wireless component is switched off. ► Switch the w ireless componen t on (see
"
Switching the wireless components on and
off", Page 40).
The wireless c ompo nent is switched on. Despite
this, the wireless connection to a n etwork does
not work.
► Ch eck whether the wireless connection is
enabled by the software.
► Fu rther information on using the wireless
component can be fou nd in the help files.
The battery discharges
too quickly
Battery
Cause
Troubleshooting
The battery is either
too hot or too cold. In this
case the batt ery indi
cator flashes.
► Bring the Tablet PC up/down to a normal
operating temperature again.
► If the operating time of the ba ttery life is
extremely short, the battery is probably too
old. Replace the battery if necessary.
You may have an application r unning that
consumes a great deal of power due to frequent
accessing of the hard disk or optical drive.
► Use th e AC adapter whenever possible.
The m aximum brightness may have been set
for the screen.
► Re duce the brightness of the scree n to
lower energy consumption: You will find the
setting under Control Panel – Hardware and
Sounds – Windows Mo bility Center.
SmartCard re
ader is not recognized
Cause
Troubleshooting
Chip card inserted incorrectly.
► Make sure yo
u have inserted your
SmartCard
into the SmartCard reader with
thechipfa
cing upwards.
► Ch eck w hether the SmartCard you are using
is supported. Your SmartC ard must comply
with the ISO standard 7816-1, -2, -3 and -4.
SmartCard PIN forgotten
Cause
Troubl
eshooting
PIN forgotten ► If you work in a netwo rk, contact your
system administrator, w ho can unlock your
Tablet PC using a supervisor PIN.
74 Fujitsu
To Next Page
Loading...
