Accessories for your Tablet PC (op ti
onal)
Setting up the cradle
Select a suitable location for the crad le before setting it up. In doing
so, please follow these instructions:
• Placethecradleonaflat, stable, non-slippery surface.
• Never place th e cradle or the AC adapter on a heat-sensitive surface.
• Do not expose the cradle to extrem e environmental conditions.
Protect the cradle from dust, moisture and heat.
Connecting the Tablet PC to the cradle
It is possible to connect the Tablet PC to the cradle while it is running. To prevent
problems, w e recommend that you switch the Tablet PC off first.
Disconnect the AC adapter from the Tablet PC before connecting
the Tablet PC to the cradle.
When the Tablet PC i
s connected to the cradle, you must conn ect
the AC adapter to t
he cradle.
Information for u
sing the docking cradle:
• If your Tablet PC
is connected to the docking cradle, the micro U SB port of the
Tablet PC canno
t be used. Use the alternative ports of the cradle.
• The HDMI and VGA ports of the docking cradle cannot be used at the same time. If
devices are connected to both ports, only the device at the HD MI port can be used.
• The maximum supported resolution for VG A/HDMI is 19 20 x 1080 pixels.
Cradle
► Sw itch the Tablet PC off.
► Remove the AC
plug of the AC adapte r from the power outlet.
► R emove the AC adapter cable from the DC jack (DC IN) of the Tablet PC.
44 Fujitsu
To Next Page
Loading...
Need help?
General