9.2 The keyboard and screen
Before starting up the machine, it is recommended to become familiar with the viscometer controls seen in
the previous section. The instrument has a 6 capacitive keyboard (Fig. 6) and a 4-lined Alphanumeric Display
screen (Fig. 2, number 1) on the frontal part ready to use and they allow the user to interact with the
machinery. The screen always shows the operations that the user is carrying out by showing menus that will
be explained later on. The measurements collected by the instrument will also be explained in this manual.
The keyboard gives the user the mobility throughout all of the menus, the selection of different options and
the creation and/or modification of viscosity measurement configurations to suit the user’s needs.
The keyboard has the following configuration:
Fig. 6 The keyboard for the ONE viscometer
The different numbered keys will always allow you to type in the proper numerical value (if a modifiable
field has been selected).
Go to the previous option; increase a value when a field has been
selected.
Go to the next option; decrease a value when a field has been
selected.
The field selected changes in some menus.
Return to previous screen and stop the motor during
measurements.
Accept an option or value in a field. It also allows editing to fields
that can be modified.
Stop/Start the motor during measurements.
In the following sections, the function of each key in the corresponding menus will be explained in full detail,
including the exceptions to the general operation.
To Next Page
Loading...
Need help?
General
