With the ‘ON’ key you can stop or start the motor, which allows for momentary pauses in an experiment.
When you press this key, the equipment will show the following message:
If you press the ‘QUIT’ key when you see the message above, the viscometer will abandon the measuring
and return to the main screen.
If you press the ‘ON’ key, the equipment will restart the measurements with the same configuration.
10.6 Test Profiles
FUNGILAB viscometers incorporate a group of programmable logs that allow configurations to be saved in
order to speed up use of the machine when carrying out measurements of a certain frequency.
From the main menu screen, select the Logs option by using the ‘’ and ‘’ arrows and press the ‘ENTER’
key to accept. The viscometer will show the following screen:
Select profiles
Edit profile
The first option will start a measurement with some configurations already recorded in the instrument’s log
and the second is for saving the measurement options of a new configuration. Select one field or the other
by using the ‘ENTER’ key.
10.6.1 Edit Test Profile
To select this option, the ‘ENTER’ key should be pressed when the cursor “” is placed on the “Edit profile”
option line. The viscometer will show the following screen:
To choose one of the logs, use the ‘TAB’ key. In the log recording there are three option blocks that you
must configure once the desired log has been chosen. We will now explain viscometer programming,
output conditions and specific configurations for the measurement.
To Next Page
Loading...
Need help?
General
