1. OPERATIONAL OVERVIEW
1-14
1.14 User Settings
The user functions shown in the table below can be reset to their default settings by
enabling the [PILOT SETTING] option in the [USER SET] menu. Functions not shown
in the table below maintain their previous setting.
The unit can store two separate user settings, for the functions listed below, in the in-
ternal memory. These settings can also be recalled. Functions not shown in the table
below cannot be stored or recalled.
Function Setting(s) Menu/On-screen box
GAIN Maintained as per
previous setting.
[GAIN] box
SEA [AUTO] [SEA] box
RAIN [AUTO] [RAIN] box
TUNE [AUTO] [TUNE] box
Range [6 NM] [RANGE] box
Range rings [OFF] [MAIN MENU] [NAVTOOL] [RANGE
RING]
VRM1 Display [ON] [VRM1] box
Distance [0.250 NM]
VRM2 Display [OFF] [VRM2] box
Distance [0.000 NM]
EBL1 Display [ON] [EBL1] box
Bearing Maintained as per
previous setting.
Reference [TRUE] [MAIN MENU] [NAVTOOL]
[EBL•VRM•CURSOR] [EBL•CURSOR
BEARING]
EBL2 Display [OFF] [EBL2] box
Bearing [000.0°]
Reference [TRUE] [MAIN MENU] [NAVTOOL]
[EBL•VRM•CURSOR] [EBL•CURSOR
BEARING]
PI Lines Display [OFF] [PI Line] box
Interval
Orientation
Bearing (True
or Relative)
[MAIN MENU] [NAVTOOL] [PI LINE]
[PI LINE BEARING] *
1
Number of PI
lines
[MAIN MENU] [NAVTOOL] [PI LINE]
[SET ALL PI LINE]
Mode
(Parallel or
Perpendicular)
[MAIN MENU] [NAVTOOL] [PI LINE]
[PI LINE MODE]
Presentation Mode [NORTH UP TM] [PRESENTATION MODE] box
Stabilization mode (Sea/
Ground)
[GPS] (Ground) [SPEED] [SHIP SPEED]
Off-centering On-centering
OFF CENTER key.*
2
Target
trails
Display, time [ON], [6 MIN] [TRAIL MODE] box
Mode [TRUE] [PAST POSN] box
Continued on following page
To Next Page
Loading...
