Furuno FS-5000 - Page 50

FS-5000/8000
A3-3
Setting No.
Channel
No.
Function
0 1 2 3 4
9917 50 ohm BK. relay ON/OFF ON (Fixed)
9918 Time adj. (Clock) Auto Manual
9919 Control unit priority NO 1 (Local) 2 (Remote)
9920 Beep sound ON/OFF OFF ON (Fixed)
9921 Beep sound level 6 (Selectable:0-10)
9922 Beep sound freq. 2000Hz (Selectable:100-3000Hz)
9923 Dummy Enable Disable
Shortening
capacitor
9924 Lower limit 2500kHz
9925
Freq. rang in which shortening
capacitor tunes on.
(9923 should be set at "2")
Upper limit 3999.9kHz
9926 Test tone Enable Disable
9927
Power reduction on
2182/2187.5kHz
Enable Disable
9928 Minimum output power
Less then
60W
60W or
more
9930 Data to "REM1" terminal
MIF
(4800bps)
TBUS CIF NMEA
MIF 2
(1200bps)
9931 Data to "REM2" terminal
MIF
(4800bps)
TBUS CIF NMEA
MIF 2
(1200bps)
9932 Data to "REM3" terminal
MIF
(4800bps)
TBUS CIF NMEA
MIF 2
(1200bps)
9933 Data to "CIF" terminal
MIF
(4800bps)
TBUS
CIF NMEA
MIF 2
(1200bps)
9934
Class of emission of TX/RX, when
unit connected to "REM1" is once
keyed.
No change SSB AM TLX
9935
Class of emission of TX/RX, when
unit connected to "REM2" is once
keyed.
No change SSB AM TLX
9936
Class of emission of TX/RX, when
unit connected to "REM3" is once
keyed.
No change SSB AM TLX
9937
Class of emission of TX only while
unit connected to "REM1" is
keyed.
No change SSB AM TLX
9938
Class of emission of TX only while
unit connected to "REM2" is
keyed.
No change SSB AM TLX
9939
Class of emission of TX only while
unit connected to "REM3" is
keyed.
No change SSB AM TLX