Furuno FS-5000 - Page 51

FS-5000/8000
A3-4
Setting No.
Channel
No.
Function
0 1 2 3 4
9940
Receiver bandwidth in kHz : SSB
(Changeable thru keyboard)
6kHz
3kHz 0.3kHz
9941
Receiver bandwidth in kHz : CW
(Changeable thru keyboard)
6kHz 3kHz
0.3kHz
9942
Receiver bandwidth in kHz : TLX
(Changeable thru keyboard)
6kHz 3kHz 0.3kHz
9943
Receiver bandwidth in kHz : AM
(Changeable thru keyboard)
6kHz 3kHz 0.3kHz
9944
Receiver bandwidth in kHz : R3E
(Changeable thru keyboard)
6kHz 3kHz 0.3kHz
9945
Receiver bandwidth in kHz : FAX
(Changeable thru keyboard)
6kHz 3kHz 0.3kHz
9946
Receiver bandwidth in kHz : LSB
(Changeable thru keyboard)
6kHz 3kHz 0.3kHz
9947 Squelch on telex mode No change OFF
9948 Noise blanker on telex mode No change OFF
9949 AGC on telex mode No change FAST
9950 Duplex mode on telex mode No change Disable
9951
Receiving antenna on telex mode
(Only when optional R.ANT SEL
board is installed.)
Main
(Not used)
Dup (Used)
9952
Tx antenna status at reception
OFF
(No change)
ON
(To GND)
9953
Operation on AM mode
T/RX RX only Disable
2182kHz
only
9954 Operation on R3E mode T/RX RX only Disable
9955 Operation on FAX mode T/RX RX only Disable
9956 Operation on LSB mode T/RX RX only Disable
9957
Cypher communication (Vs Enable
control signal ON/OFF on TB2-10
in FS-5000C unit)
Disable Enable
9960 Recall of 27MHz SSB/DSB freq. Disable Enable
9961 ITU freq. Table selection Standard USA Europe
9962
MF band : 405-526.5kHz
transmission (When optional MF
tuner : AT-410 is installed.)
Disable Enable