21
2General
2.8 Issue of letter of no objection
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
2.8.2 Required documents
In individual cases, the body drawings may be
submitted to the department responsible before the
start of work É 2.1. The drawings shall contain the
following information:
• All deviations from MITSUBISHI FUSO body/
equipment mounting directives.
• Complete data on dimensions, weights and center
of gravity (weight certificates)
• Attachment of body to the chassis
• Vehicle operating conditions, e.g.
–on poor roads
– in very dusty conditions
– at high altitude
– at extremely high or low ambient temperatures
• Certificates ("e" mark, seat tensile strength test,
etc.)
Submitting the required documentation in full will
make queries on our part unnecessary and will speed
up the approval procedure.
If complex calculations and/or vehicle tests are
necessary for the no objection check, all costs
incurred must be borne by the vehicle body/conver-
sion manufacturer or its client. The extent of testing
required is defined by the relevant department of
Daimler and MITSUBISHI FUSO development.
2.8.3 Legal claim
• No legal claim can be made as to the issue of a
letter of no objection.
• MITSUBISHI FUSO TRUCK & BUS CORPORATION
reserves the right to refuse the issue of a letter of
no objection due to ongoing technical
development and the knowledge gained from it,
even if a similar certificate was issued in the past.
• The letter of no objection may be restricted to
individual vehicles.
• Subsequent issuance of a letter of no objection for
vehicles already completed or delivered can be
refused.
The body manufacturer alone shall be responsible for:
• The functionality and compatibility of its bodies
and equipment, fittings and conversions with the
basic vehicle
• Operating and road safety
• All bodies and equipment, fittings, conversions and
installed parts
To Next Page
Loading...