27
3 Planning of bodies
3.5 Tires
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
3.5 Tires
The body manufacturer must ensure that:
• the largest permissible MITSUBISHI FUSO
authorized tires can be fitted.
• the distance between the tire and the mudguard or
wheel housing is sufficient even when snow or anti-
skid chains are fitted, with the suspension fully
compressed (including any twist) (Adherence to
valid regulations).
• that the relevant information in the drawings is
observed.
If the option of fitting snow and anti-skid chains
cannot be guaranteed, the operator should be
informed by the body manufacturer (operating
instructions).
Comply with national regulations governing the
approval of tires. These regulations may define a
specific type of tire for your vehicle or may forbid the
use of certain tire types which are approved in other
countries.
a Risk of accident
Exceeding the specified tire load-bearing capacity
or the permissible maximum tire speed can lead to
tire damage or failure. You can lose control of the
vehicle, cause an accident and injuries.
For this reason, only fit tires of a type and size
approved for your vehicle and observe the tire load-
bearing capacity required for your vehicle. Observe
tire speed index.
! Property damage
If you have other wheels fitted
• the brakes or components of the suspension
system could be damaged
• wheel and tire clearance can no longer be
guaranteed
• the brakes or components of the suspension
system can no longer function correctly.
To Next Page
Loading...