24
3 Planning of bodies
3.3 Dimensions, weights, overall vehicle height
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
3.3 Dimensions, weights, overall vehicle height
Dimensions and weight details can be found in the
drawings and technical data. They are based on a
vehicle that is fitted with standard equipment. Weight
tolerances of ±3% in production must be taken into
consideration (1230/2012/EC).
For the minimum mass of the vehicle, refer to "10.2
Specification" (1230/2012/EC).
The permissible axle loads and the maximum
permissible gross vehicle weight specified in the
technical data may not be exceeded.
The technical data can be found in the vehicle
documents or on the vehicle model plate.
a Risk of accident
The vehicle tire load capacity may not be exceeded
by overloading the vehicle beyond its specified
gross vehicle weight. The tires could overheat and
suffer damage. This could cause you to lose control
of the vehicle and cause an accident with possible
injury to yourself and others.
Information on the permissible axle loads can be
found on the vehicle model plate.
All legal provisions governing the permissible
vehicle height must be taken into account when
planning bodies.
In the Federal Republic of Germany the permissible
vehicle height is limited to max. 4 m. In other
countries (and if the vehicle is operated on
international services), comply with all the relevant
national regulations.
i Additional information
Information about changes in weight is available
from the department responsible É 2.1.
For details of maximum rear body width, refer to
"4.7 Others" É 4.7.
To Next Page
Loading...