76
5 Damage prevention
5.10 Electromagnetic compatibility (EMC)
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
5.10 Electromagnetic compatibility (EMC)
The different electrical consumers on board the
vehicle cause electrical interference in the vehicle's
electrical circuit. MITSUBISHI FUSO tests the
electromagnetic compatibility in the vehicle of all
factory-installed electrical and electronic
components.
When retrofitting electric or electronic systems, they
must be tested for electromagnetic compatibility and
this must be documented.
The equipment must possess type approval in
accordance with EC Directive 72/245/EC (in its
currently valid version) and must bear the CE mark.
An alternative to this is testing and labeling as per UN-
R 10 with the corresponding CE mark.
The following standards provide information on this:
• The current valid version of EC directive 72/245/
EC (currently 2009/19/EC)
• UN regulation UN-R 10
•CISPR 12
• ISO 7637
• ISO 11451
• ISO 11452
When retrofitting two-way radio systems, the
installation notes as per ISO/TS 21609 must be
observed.
i Additional information
Observe the notes on operational and vehicle safety
(É 1.3) and (É 1.4).
To Next Page
Loading...