64
5 Damage prevention
5.5 Painting work
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
5.5.2 Precautions to be observed when drying the paint
• Forced drying
In order to protect resin and rubber parts, ensure
that the temperature of the painted surface does
not exceed 80°C.
If the temperature is likely to exceed 80°C, either
remove the following parts or take steps to protect
them from heat.
Parts to be removed or shielded from heat when repainting at temperatures exceeding 80°C
Natural drying
In this case, no resin or rubber parts must be removed
from the vehicle.
1. Exterior mirror
2. Mirror stay
3. Corner panel including
caps for mounting
4. Front cover
5. Emblem
6. Bumper corner cover
7. Front grille (Including caps
screws for fitting hole in
cab)
8. Lamp, etc.
9. Step
10. Fender
11. Door delta garnish
12. Door outer handle
13. Door belt line molding
14. Door weatherstrip
15. Door sash garnish
16. Door runchannel
17. Screw seal washer
18. Rear window weatherstrip
(cab)
19. Lamps
20. Wind shield weatherstrip
21. Wiper
22. Aerial
23. Rader Cover
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18. 19. 20. 21.
22.
23.
i Additional information
• Clear acrylic urethane can be susceptible to
blistering. More information can be obtained
from the paint manufacturer/supplier.
• The surfaces must be roughened before
repainting, otherwise the paint layer might
adhere poorly.
To Next Page
Loading...