66
5 Damage prevention
5.5 Painting work
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
5.5.4 Repainting of the cab
• When a standard-color-coated cab is repainted,
plastic and rubber parts on it should be removed
where possible to protect them from adverse
effects.
*1
The caps covering the holes in the cab for mounting the radiator grille and corner panels cannot be reused
once removed. Replace them with new ones.
*2
Before reinstalling removed door weatherstrips, check their plastic clips for deformation in claws and defects
preventing smooth insertion. Any defective clips must be replaced with new ones.
• Before the cab is shipped from the factory, it is
coated with a non-sanding type high-adhesion
natural white paint only. However, in order to
completely remove oil, grease and other
contaminants from the surfaces to be painted, it is
recommended that you sand these surfaces.
Paint other than natural white is not high-adhesion
paint. When using paint of a different color, be sure
to sand the surfaces to be painted before applying
the paint.
(Sanding procedure: Sand the surfaces uniformly
with #400 sandpaper until the gloss disappears
from the surface.)
Removable parts Parts to be masked
•Emblems
•Front grille
*1
•Corner panels
*1
•Front cover
•Steps
•Fenders
•Wipers
•Aerial
•Lamps
•Exterior mirrors, mirror stays
•Bumper corner covers
•Heat protector (at back of cab)
•Sealing washers for screws
•Rader Cover
•Door outer handles
•Weatherstrips
*2
•Caution labels
•Door delta garnish
•Door runchannels
•Door sash garnish
•Door beltline moldings
Part name Part No.
Clip MK676916 (MITSUBISHI FUSO part number)
Part name Part No.
Clip MK402586 (MITSUBISHI FUSO part number)
To Next Page
Loading...