When sensor registration or slot number change was
performed and the message
"
Failed. The connected sen-
sor is not ready.
"
was displayed, check the sensor con-
nection. If the sensor is rmly connected, the sensor or
transmitter is probably faulty.
Sensor Menu
All the sensors to be used are connected to
the T4PX
.
Sensor Reload
This function secures contiguous unused slots by rearranging the registration state when
sensor registration and deregistration are performed repeatedly and the unused slots are
fragmented.
1
(Reload)
Select "Reload" by (JOG) button up or down operation and
pressthe (JOG)button. Theconrmation message"Are you
sure?" appears. To execute reload, select "Yes" and to cancel
reload, select "No" with the (JOG) button and press the (JOG)
button. If the message "Success" is displayed, reloading is
complete.
Sensor reload
2
When ending setting, return to the Sensor menu screen by pressing the (END) button.
Setup item selection
- Select by (JOG) button up or
down operation.
Reload button
- (JOG) buttons pressed.
Pres
To Next Page
Loading...