HOME
screen
or
MENU 2 screen
MENU 1
screen
When the condition function is
turned on, the condition copy display
becomes active and the condition is
enabled.
140
Condition Function
Two kinds of data can be set in one model for specic functions only; for example, two
kinds of data such as steering D/R set to 90% at normal condition and steering D/R set to
80% at second condition. This second condition can be set for each model.
-The functions that can be set at each condition are displayed by condition number at the top
of the menu screen. Since the reverse function, end point and other model standard setup
menus are not displayed by conditioner number, the condition 1 and condition 2 settings are
common.
- To use the condition function, switch setting by function select switch (p.99) is necessary.
- Switching from normal condition to second condition by switch set by function select
switch is indicated by an audible alarm, and the condition number is displayed in the upper
on the screen.
-First, the initial settings of each condition 2 function are created.
-The data set at condition 2 is memorized until reset by model reset (p.116). The data is
memorized even if the condition function is turned off or setting of the SW by switch set-
ting function is changed.
Condition Function
Setting item
Mode(fubction ON/OFF)
Condition copy
Pres
To Next Page
Loading...