FUTABA 4PX - Sensor Register

Communication port
Sensor (The battery is not necessary)
Cover
Sensor menu screen
138
Function
Sensor Menu
Connecting S.BUS/S.BUS2
servo connector to the trans-
mitter Communication port.
Sensor Register
This function registers an additional sensor. Connect the sensor as shown in the gure and
register it by the following procedure. The sensor ID is registered in the transmitter.
This function is set when using multiple telemetry sensors of the same type.
1
(Register)
Select "Register" by (JOG) button up or down operation and
pressthe(JOG)button.Theconrmationmessage"Areyou
sure?" appears. To execute registration, select "Yes" and to
cancel registration, select "No" by (JOG) button and press
the (JOG) button. If registering a sensor that has already
been registered is attempted, the message "Failed" will be
displayed.
Sensor register
2
When ending setting, return to the Sensor menu screen by pressing the (END) button.
Setup item selection
- Select by (JOG) button up or
down operation.
Register button
- (JOG) buttons pressed.
Pres
s