FUTABA 4PX - Trigger; Neutral Brake

Warning display
If the power switch is turned on while the neutral
brake switch is on, an audible alarm will be heard.
Immediately set the neutral brake switch to OFF.
67
Function
Trigger
Neutral brake
On
Neutral brake
O ff
Neutral brake ON/OFF is dis-
played by pop-up window in
the home screen.
(Preparation)
- Use the function select switch function to select the switch. (p.99)
1
(Neutral brake rate)
Select the setting item "Neutral brake" by (JOG) button up or down operation. Use the (+)
and (-) buttons to set the neutral brake rate.
Neutral Brake function adjustment
2
When ending setting, return to the menu screen by pressing the (END) button.
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "100" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Neutral Brake
0~100
The ESC neutral brake function and T4PX neutral brake function can be used simulta-
neously. However, when setting is difcult to understand, we recommend that only one
neutral brake function be used.
Reference
When the neutral brake function is
"
ON
"
, the neutral brake rate adjustment is automati-
cally assigned to the throttle trim (DT1~DT6 or DL1).
Dial / Trim Setting
Throttle side EPA function, or ATL function setting also affects neutral brake side op-
eration.
The Idle-up (p.69) or Engine Cut (p.71) function has priority.
Effect of set value of other functions on neutral brake