FUTABA 4PX - Neutral Brake function adjustment

Forward50:Brake50
Forward70:Brake30
Forward100:Brake0
Trigger switch point
-100~+100
Initial value: +100
Setting buttons
- Use the (+) and (-) buttons to
make adjustments.
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
68
Function
(Preparation)
-This function is the switch select function (p.99) and sets the functions used at switch TS.
-The standard is trigger high direction ON. When set to ON by brake direction, the direction
is set to reverse at the switch setup screen.
Trigger switch setting method
Trigger
1
(Trigger switch ON/OFF point setting)
Select the setting item trigger switch by (JOG) button up or
down operation.
Set the ON/OFF switching point
by (+) and (-) button.
The ON/OFF switching point can
also be set by holding the trigger
in the position to be set as the ON/
OFF switching point and pressing
the (JOG) button. Fine adjustment
is possible by (+) and (-) button.
The red part of the bar graph is the ON direction.
2
When ending setting, return to the menu screen by pressing the (END) button.
1
(Throttle mode selection)
Select the setting item "Ratio" by (JOG) button up or down operation.
Select "Forward 50:Brake 50",
"Forward 70:Brake 30" or "For-
ward 100:Brake 0" by (+) or (-)
button.
Selecting the trigger ratio
2
When ending setting, return to the menu screen by pressing the (END) button.