With A.B.S.
Without A.B.S.
Setup items
Mode (Function On/Off)
Brake return amount
Delay amount
Cycle speed
Trigger point
Duty ratio
Steering mixing
HOME
screen
or
MENU 1 screen
The servo view screen is
displayed.
When brake operation enters
the ABS set range, several
"ON" are displayed.
A.B.S Function
The
display appears on the home screen.
Operation display
MENU 2
screen
When trigger ratio (p.66) was set to 100:0, brake operation stops, and the servo does not
operate even if the ABS function is set.
When trigger ratio was set to 100:0
- When the brakes are applied, the throttle servo will pulse
intermittently. This will have the same effect as pumping
the brakes in a full size car.
- The brake return amount, pulse cycle, and brake duty can
be adjusted.
- The region over which the ABS is effective can be set ac-
cording to the steering operation. (Mixing function)
Operation
A.B.S. Function
(Throttle system)
When the brakes are applied while cornering with a 4 Wheel Drive
or other type of vehicle, understeer may occur. The generation of
understeer can be eliminated and corners can be smoothly cleared
by using this function.
To Next Page
Loading...