FUTABA 4PX - Warning Displays

161
Reference
- To stop the alarm, turn off the power.
- Turn the power back on. If the alarm is not generated
again, there is no problem.
- To stop the alarm, turn off the power.
- Turn the power back on. If the alarm is generated again,
request repair from the Futaba Service Center.
Backup Error
RF Error
System Error
Audible alarm:
Tone sounds (7 times) and stops (repeated)
Audible alarm:
Tone sounds (7 times) and stops (repeated)
Audible alarm: Continuous tone.
The vibrator: Active (initial setting) page 148
Warning
When a system error is generated, immediately stop using
the system and request repair from the Futaba Service Cen-
ter.
If you continue to use the system, the transmitter may malfunction and cause
If the data in the transmitter is not transferred normally when the power is turned on, an au-
dible alarm will sound and "Backup error" will be displayed on the LCD.
When the RF module does not operate,
"
RF Error
"
is displayed on the LCD.
If the power is turned on during charging, an RF error will be displayed and an audible
alarm will sound. Immediately turn off the power.
If the data is lost for an unknown reason, an audible alarm will sound and "System error"
will be displayed on the LCD screen.