FUTABA 4PX - Brake mixing adjustment

Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Delay amount
100 ~ 0
Initial value:0
Adjustment buttons
- Use the (+) and (-) buttons to
make adjustments.
- Return to the initial value by
pressing the (+) and (-) buttons
simultaneously (approx. 1 sec).
Brake rate
Steering mixing(L)
Steering mixing(R)
0 ~ 100
Initial value:100
5
(Delay amount setup)
Select setup items "Brake1"
Delay or Brake2,3 -Delay" by
(JOG) button up, down, left or
right operation, and use the (+)
and (-) buttons to adjust the
delay amount.
-Since a delay at all the brakes is dangerous, a delay is not applied to the
brake to be adjusted last.
For example, when brakes 1, 2, and 3 are all used, when a delay is ap-
plied to brakes 2 and 3, a delay cannot be applied to brake 1. When a
delay must be applied to brake 1, the brake 2 or brake 2 delay must be
set to "0".
6
(Steering mixing)
Use this function when you
want to weaken the brakes
when steering was operated.
Select the setting item "Steer-
ing mixing(L)" or "Steering
mixing(R)" by (JOG) button up,
down, left, or right operation.
Use the (+) or (-) button to ad-
just the brake amount.
Use "Steering mixing(R)" Brake1,2,3 to adjust the brake
amount relative to the steering right operation amount. and
"Steering mixing(L)" Brake1,2,3 to adjust the brake amount
relative to the steering left operation amount. The smaller
the value, the weaker the front brakes. Set value "100" is the
state in which steering mixing is not performed.
- The mixing amount can be adjusted in a range from 0 to 100.
7
When ending setting, return to the Mixing menu screen by
pressing the (END) button.
The function select dial function can control the brake 1,2,3 rate , delay amount and EXP
setting using digital dial or digital trim. (p.101)
Dial / Trim Setting
83
Function
Brake Mixing