FUTABA T10PX - Channel Setting

101
Returntotableofcontents
Adjust button
Adjust with the [+] and [-] but-
tons.
- Return to the initial value by
tapping the [reset] buttons.
Position
-100~0~+100
Initial value: 0
The number of channels
varies depending on the se-
lected system.
Channel Setting
This function assigns steering or throttle to any channel. You can operate steering and
throttle on other channels, and operate other channels in the same way as steering and
throttle.
1
(Channel setup)
Tap the channel you want to set, and the
[Steering], [Throttle] setting screen will be
displayed. Tap on [Steering] or [Throttle]
set for that channel and select it. To cancel,
tap [Close].
How to select steering/throttle
2
(Position setting of the auxiliary channel)
If there is no switch, trim/dial, etc. To oper-
ate the auxiliary channel, you can set the
position here.
Tap the rate display part of the channel you
want to adjust. Value input buttons appear
on the channel setting menu screen. Use
the [+] or [-] button to adjust the position.
3
When finished, return to the Linkage menu screen by pressing the HOME button.
LINKAGE MENU
Home screen Menu screen
Menu-1 Menu-2
Channel limiter
Linkage menu screen