FUTABA T10PX - Fail-SafeBattery Fail-Safe

82
Returntotableofcontents
* When fail-safe is set, that servo position is displayed.
Servo position
Tap to change page.
The number of channels var-
ies depending on the selected
system.
Fail-safe/Battery Fail-safe
This function sets the servo operation position when transmitter signals cannot be re-
ceived by the receiver for some reason, or the battery voltage has dropped.
-Fail-safe mode
This function moves each servo to a preset position when the receiver cannot receive
the signals from the transmitter for some reason.
* The fail-safe data is transferred from the transmitter to the receiver 10-seconds after the transmitter power
was turned on.
* Note: Normally, the transmitter is turned on before the receiver, so the receiver will not receive data for about
10-seconds after the receiver is turned on.
* For gasoline engine cars, for safety, we recommend that this fail-safe function be used to set the throttle
channel in the direction in which the brakes are applied.
-
Hold mode
This function holds the receiver in its position immediately before the reception was lost.
-
2൵PRGH2))
This function stops the output of signals to the servos and places the servos into the
free state when the receiver cannot receive it.
The F/S, HOLD, and OFF modes are automatically reset when signals from the trans-
mitter can be received again.
)RU)*&+&+FDQQRWEHVHWWR2൵PRGH
-
Battery fail-safe function (B-F/S)
,IWKHUHFHLYHUEDWWHU\YROWDJHGURSVEHORZDVSHFL¿FYDOXHZKHQWKLVIXQFWLRQLVHQ-
abled, the throttle servo moves to the position set by fail-safe function. When the bat-
tery voltage recovers, the battery fail-safe function is automatically reset.
* This function cannot be used when the channel is not set to fail-safe.
LINKAGE MENU
Home screen Menu screen
Menu-1 Menu-2
Fail-safe
Linkage menu screen